INSTALLATION PROCEDURE
1. Cut to pipe diameter marked on Flashers (approximately 20% smaller than the diameter of the pipe).
2. Slide the Flashers down the pipe, using water to lubricate if necessary.
3. Form and bend the aluminum base of the Flashers to fit the surface of the roof.
4. Seal the Flashers by applying urethane/silicone sealant between the Flasher and the roof. Use a large slot screwdriver to press the base down tightly.
5. Fasten the Flashers with weather-resistant fasteners to complete the seal.
|
SIZE CHART |
|||||||
|
Standard |
High Temp |
||||||
|
Flasher Size |
#1 | #2 | #3 | #6 |
#3 |
#5 | |
| Outside Pipe Diameter | 1/4" - 2" | 1 3/4"- 3 1/4" | 1/4" - 5" | 5" - 9" |
1/4" - 5" |
4 1/4"- 7 1/2 | |
902
Kershaw St. / PO Box 2282
Gadsden, AL
35903
--VIEW
MAP--
(256)
492-6032
Toll Free (888) 870-7663
americanoverheaddoor@comcast.net